Filter
Top Products
MERLIN LEGEND Communications System Release 5.0
System Manager’s Guide
555-650-118
Issue 1
June 1997
Managing the System
Page 6-46Changing Calling Restrictions
6
Task List: Assigning a HotLine Extension 6
Assemble any required system planning forms, for example, System Form
4f, Tip/Ring Equipment.
Open the System Programming menu from the console or a PC with SPM.
If necessary, assign a personal line to the extension, following the
instructions in “Assign Trunks or Pools to Telephones” in the “Telephones”
section of
System Programming
, Chapter 3.
NOTE:
This task requires an idle condition: Extension Forced Idle.
If necessary, assign or delete intercom or System Access buttons by
following the instructions in “Assign Intercom or System Access Buttons” in
the “Telephones” section of
System Programming
, Chapter 3.
Program Personal Speed Dial code 01 with the inside or outside number
required, including any ARS or other access codes as necessary. You can
use extension programming to program the code at the single-line
telephone, or you can program the number using centralized telephone
programming (see ‘‘
Centralized Telephone Programming’’ on page 6-23).
If necessary, program the line at the extension for No Ring (see
‘‘
Centralized Telephone Programming’’ on page 6-23).
If Night Service with Outward Restriction is in use on your system, you may
need either to add the HotLine extension to the Night Service Exclusion
List or add the number dialed by a HotLine to a Night Service Emergency
List.
When you have finished, file the form(s) with the rest of the planning forms.
Programming Instructions 6
Changing Calling Restrictions 6
Use this procedure to change individual extensions’ calling restrictions to one of
the following:
■ Unrestricted
■ Restricted from making all outgoing calls
■ Restricted from making toll calls
Console Procedure
Extensions→More→More→HotLine→Dial ext.
no.
→Enter→Exit→Exit
PC Procedure → → → →Type ext. no.→ →
→
→