Filter
Top Products
MERLIN LEGEND Communications System Release 5.0
System Manager’s Guide
555-650-118
Issue 1
June 1997
Managing the System
Page 6-47Changing Calling Restrictions
6
In Release 3.1 and later systems, checking for calling restrictions is reset after
entered star codes pass those restrictions (in some areas, star codes are
provided by the central office to allow the use of special features available from
the local telephone company). In earlier releases, the star code digits were
processed as dialed digits by ARS, Allowed Lists, Disallowed Lists, and calling
restrictions. Therefore, the actual called party number was not properly processed
when a star code was entered. For more information about star codes, see
‘‘
Revising Allowed Lists’’ on page 6-69.
Planning Guidelines 6
Changing calling restrictions may affect other features, including Allowed Lists,
Auto Dial, Automatic Route Selection (ARS), Callback, Conference, Coverage,
Disallowed Lists, Display, Extension Status, Forward and Follow Me, Night
Service, personal lines, Pools, Speed Dial, and SA/ICOM buttons. For more
information, see the
Feature Reference
.
NOTES:
1. You can copy restrictions from another extension as described in
“Copy Call Restrictions” in the “Optional Telephone Features” section
of Chapter 3 in
System Programming
.
2. In Release 3.1 and later systems, ports programmed for voice
messaging systems (VMI ports) are factory-set as outward-restricted.
To permit outcalling from a voice messaging system, you must change
this restriction.
Valid Entries
Unrestricted, Outward-restricted, Toll-restricted
Task List: Changing Calling Restrictions 6
Obtain the following forms, as appropriate:
— 6g, Call Restriction Assignments and Lists
— 6e, Allowed Lists
— 6f, Disallowed Lists
— Forms for individual telephones: Forms 4b, 4d, 4e, 4f, 5a, 5b, or 5c
If necessary, read “Calling Restrictions” in the
Feature Reference
for
detailed information about this feature.
Plan changes using the planning guidelines above; record the new values
on the form(s).
Open the System Programming menu from the console or a PC with SPM.