Filter
Top Products
Intel® Server Board SE7501WV2 TPS Configuration Jumpers
Revision 1.0
Intel reference number C25653-001
157
9. Configuration Jumpers
This section describes configuration jumper options on the SE7501WV2 server board.
9.1 System Recovery and Update Jumpers
The SE7501WV2 server board provides one 11-pin single inline header (J1D4), which provides
a total of three 3-pin jumper blocks that are used to configure several system recovery and
update options.
Figure 11. Intel
®
Server Board SE7501WV2 Configuration Jumpers (J1D4)
The following table describes each jumper option. Please note that pins 4 and 8 are removed.
Table 94. Configuration Jumper Options
Option Description
CMOS Clear If pins 1 and 2 are jumpered (default), preservation of configuration CMOS through system reset is
controlled by the BMC. If pins 2 and 3 are jumpered, CMOS contents are set to manufacturing default
during system reset.
Password
Clear
If pins 5 and 6 are jumpered (default), the current system password is maintained during system reset.
If pins 6 and 7 are jumpered, the password is cleared on reset.
Recovery
Boot
If pins 9 and 10 are jumpered (default), the system will attempt to boot using the BIOS programmed in
the Flash memory. If pins 10 and 11 are jumpered, the BIOS will attempt a recovery boot, loading
BIOS code from a floppy disk into the Flash device. This is typically used when the BIOS code has
been corrupted.
CMOS CLEAR
PASSWORD CLEAR
RECOVERY BOOT