Filter
Top Products
3-42
Garmin G600 Pilot’s Guide
190-00601-02 Rev. E
Foreword
Sec 1
System
Sec 2
PFD
Sec 3
MFD
Sec 4
Hazard
Avoidance
Sec 5
Additional
Features
Sec 6
Annun.
& Alerts
Sec 7
Symbols
Sec 8
GlossaryAppendix A
Appendix B
Index
Class C/TCA Airspace Viewing Range
The Class C/TCA airspace viewing range option selects whether Class C/TCA
airspace information is shown on the Navigation Map. Class C/TCA airspace
information will be shown at and below the selected map range. When Off is
selected, the information will not be shown. In the example below where 200
NM is selected, Class C/TCA airspace information will be shown at map ranges
of 200 NM and lower.
Figure 3-57 Navigation Map Class C/TCA Viewing Range Selection
1) While viewing the Navigation Map Setup page and the Aviation Group active,
turn the large MFD knob to highlight the “
Class C/TCA
Viewing Range”
option.
2) Turn the small MFD knob to change the highlighted value.
3) Press ENT
to accept the displayed value. The next option will be highlighted.
4) Press the small MFD knob to cancel selection or to end editing and return to
the Navigation Map page or turn the large MFD knob to the next option.