Filter
Top Products
4-39190-00601-02 Rev. E
Garmin G600 Pilot’s Guide
Foreword
Sec 1
System
Sec 2
PFD
Sec 3
MFD
Sec 4
Hazard
Avoidance
Sec 5
Additional
Features
Sec 6
Annun.
& Alerts
Sec 7
Symbols
Sec 8
Glossary Appendix A
Appendix B
Index
4.8 TIS Traffic (Optional)
WARNING: The Traffic Information Service (TIS) is intended for advisory
use only. TIS is intended to help the pilot locate traffic visually. It is the
responsibility of the pilot to see and maneuver to avoid traffic.
NOTE: TIS is available only when the aircraft is within the service volume of
a TIS-capable terminal radar site. Aircraft without an operating transponder
are invisible to both Traffic Advisory Systems (TAS) and TIS. Aircraft without
altitude reporting capability are shown without altitude separation data
or climb descent indication.
NOTE: TIS and TAS are mutually exclusive.
The type of traffic systems that is installed is determined by the traffic page
display in the upper left corner of the MFD.
If Traffic Information Service (TIS) is configured, TIS will be displayed in the
upper left corner of the MFD.
Traffic Information Service (TIS) is designed to help in detection and
avoidance of other aircraft. TIS uses the Mode S transponder for the traffic data
link. TIS receives traffic information from ground stations, and is updated every
five seconds. The GDU 620 displays up to eight traffic targets within a 7.5 NM
radius, from 3000 feet below to 3500 feet above the requesting aircraft. Traffic is
displayed according to TCAS symbology using three different symbols.
4.8.1 Traffic Map Page
The Traffic Map Page is configured to show surrounding TIS traffic data in
relation to the aircraft’s current position and altitude, without clutter from the
basemap. Aircraft orientation on this map is always heading up unless there is
no valid heading.
The traffic mode is annunciated in the upper left corner of the Traffic Map
Page. When the aircraft is on the ground, TIS automatically enters Standby
Mode. Once the aircraft is airborne, TIS switches from Standby to Operating
Mode and the GDU 620 begins to display traffic information.