Filter
Top Products
4-45190-00601-02 Rev. E
Garmin G600 Pilot’s Guide
Foreword
Sec 1
System
Sec 2
PFD
Sec 3
MFD
Sec 4
Hazard
Avoidance
Sec 5
Additional
Features
Sec 6
Annun.
& Alerts
Sec 7
Symbols
Sec 8
Glossary Appendix A
Appendix B
Index
4.8.5 TIS System Status
The GDU 620 performs an automatic test of TIS during power-up. If
TIS passes the test, TIS enters Standby Mode on the ground or Operating
Mode in the air. If TIS fails the power up test, an annunciation is shown
in the center of the Traffic Map Page.
Traffic Map Page
Annunciation
Description
NO DATA* Data is not being received from the transponder
DATA FAILED*
Data is being received from the transponder, but
a failure is detected in the data stream
FAILED* The transponder has failed
UNAVAILABLE TIS is unavailable or out of range
* Contact a service center or Garmin dealer for corrective action
Table 4-16 TIS Failure Annunciations
The traffic mode is annunciated in the upper left corner of the Traffic Map
Page. When the aircraft is on the ground, TIS automatically enters Standby
Mode. If traffic is selected for display on another map while Standby Mode is
selected, the traffic display enabled icon is crossed out (also the case when TIS
has failed). Once the aircraft is airborne, TIS switches to Operating Mode and
traffic information is displayed. The mode can be changed manually using soft
keys or the page menu.
Mode
Traffic Mode Annunciation
(Traffic Map Page)
Traffic Display Enabled Icon
(Other Maps)
TIS Operating OPERATING
TIS Standby
STANDBY
(Also shown in white in center of
page)
TIS Failed* FAIL
Table 4-17 TIS Modes