Filter
Top Products
4-76
Garmin G600 Pilot’s Guide
190-00601-02 Rev. E
Foreword
Sec 1
System
Sec 2
PFD
Sec 3
MFD
Sec 4
Hazard
Avoidance
Sec 5
Additional
Features
Sec 6
Annun.
& Alerts
Sec 7
Symbols
Sec 8
GlossaryAppendix A
Appendix B
Index
Winds Aloft Data Viewing Range
The Winds Aloft Data Viewing Range option allows you to select the map
range where at and below that value Winds Aloft weather products will appear
on the selected MFD Wx Data Link Map page (1, 2, or 3). When Off is selected,
Winds Aloft will not be shown. In the figure below where 150 NM is selected,
Winds Aloft data will be shown at map ranges of 150 NM and lower.
Figure 4-63 Winds Aloft Data Viewing Range Selection
1) While viewing a WX Data Link Map page of the WX page group, press the
MENU key to display the Page
Menu Options
. The cursor flashes on the
“Weather Setup” option. Press ENT
.
2) Turn the large MFD knob to highlight the Winds Aloft Data Viewing Range
value.
3) Turn the small MFD knob to highlight the desired value. Press ENT
to accept
the displayed value. The next option will be highlighted.
4) Press the small MFD knob to cancel selection or to end editing and return to
the Navigation Map page or turn the large MFD knob to the next option.