Garmin G600 Marine GPS System User Manual


 
4-69190-00601-02 Rev. E
Garmin G600 Pilot’s Guide
Foreword
Sec 1
System
Sec 2
PFD
Sec 3
MFD
Sec 4
Hazard
Avoidance
Sec 5
Additional
Features
Sec 6
Annun.
& Alerts
Sec 7
Symbols
Sec 8
Glossary Appendix A
Appendix B
Index
METAR Viewing Range
The METAR Viewing Range option allows you to select the map range where
at and below that value METAR weather products will be shown on the selected
MFD Wx Data Link Map page (1, 2, or 3). When Off is selected, METARs will
not be shown. In the figure below where 150 NM is selected, METAR data will
be shown at map ranges of 150 NM and lower.
Figure 4-51 METAR Viewing Range Selection
1) While viewing a WX Data Link Map page of the WX page group, press the
MENU key to display the Page
Menu Options
. The cursor flashes on the
“Weather Setup” option. Press ENT
.
2) Turn the large MFD knob to highlight the METAR Data Viewing Range value.
3) Turn the small MFD knob to highlight the desired value. Press ENT
to accept
the displayed value. The next option will be highlighted.
4) Press the small MFD knob to cancel selection or to end editing and return to
the Navigation Map page or turn the large MFD knob to the next option.