Filter
Top Products
4-97190-00601-02 Rev. E
Garmin G600 Pilot’s Guide
Foreword
Sec 1
System
Sec 2
PFD
Sec 3
MFD
Sec 4
Hazard
Avoidance
Sec 5
Additional
Features
Sec 6
Annun.
& Alerts
Sec 7
Symbols
Sec 8
Glossary Appendix A
Appendix B
Index
Figure 4-83 Restore Calibrated Gain
OR
1) While viewing the Weather Radar page of the Wx page group, press the
CONTROL soft key.
2) Press the GAIN CAL soft key to restore the calibrated gain value. Press the
MFD knob again to accept the value and end editing.
4.10.6.5 Sector Scan (GWX Radars Only)
Adjusting the Sector Scan reduces the scan angle from Full in increments of
±20°, ±40°, and ±60° in horizontal scanning. Sector scanning is not available for
vertical scanning.
1) While viewing the Weather Radar page of the Wx page group, press the
CONTROL soft key.
2) Press the BRG soft key to display the Bearing Line.
3) Turn the small
MFD knob to place the Bearing Line in the desired position. The
location of the Bearing Line will become the center point of the Sector Scan.
4) Turn the large
MFD knob to place the cursor in the SECTOR SCAN field.
Figure 4-84 Sector Scan - Full
5) Turn the small
MFD knob to select FULL, 60
°
, 40
°
, or 20
°
scan.