Filter
Top Products
e-STUDIO3511/4511 ADJUSTMENT 3 - 8 November 2003 © TOSHIBA TEC
( )
3.4.2 Paper alignment at the registration roller
The aligning amount is adjusted by using the following codes in Adjustment Mode (05).
Sub-code
(*1) 0: Long size 1: Middle size 2: Short size
(*2) 0: Long size 1: Middle size 2: Short size 3: Post card
(*3) 0: Long size of thick paper 2 1: Middle size of thick paper 2
2: Short size of thick paper 2 3: Long size of thick paper 3
4: Middle size of thick paper 3 5: Short size of thick paper 3
6: Long size of OHP film 7: Middle size of OHP film
8: Short size of OHP film 9: Post card
(*4) 0: Long size 1: Middle size 2: Short size 1 3: Short size 2
Notes:
1. Long size: 330 mm or longer (13.0 inches or longer)
Middle size: 220-329 mm (8.7-12.9 inches)
Short size: 219 mm or shorter (8.6 inches or shorter)
Short size 1: 205-219 mm (8.1-8.6 inches or shorter)
Short size 2: 204 mm or shorter (8.0 inches or shorter)
2. The adjustment of “Post card” is for Japan only.
<Procedure>
Paper
type
Plain
paper
Thick
paper 1
Thick
paper 2
Thick
paper 3
OHP film
Weight
64-80 g/m
2
17-20 lb.
81-105 g/m
2
21-28 lb.
106-163 g/m
2
29-43 lb.
164-209 g/m
2
44-55 lb.
-
Upper
drawer
450 (*4)
469 (*4)
-
-
-
Lower
drawer
452 (*4)
470 (*4)
-
-
-
PFP upper
drawer
448 (*4)
471 (*4)
-
-
-
PFP lower
drawer
449 (*4)
472 (*4)
-
-
-
LCF
457
473
-
-
-
ADU
455 (*1)
474 (*1)
-
-
-
Bypass feed
Black Color
458 (*1)
460 (*1)
461 (*1) 475 (*3)
462 (*2) 475 (*3)
463 (*1) 475 (*3)
[0] [5]
[Power]
Current value
displayed
Enter new
value
[POWER]
OFF/ON
(Exit)
(Not necessary for LCF)
[Drawer selection]
(*5) + [FAX]
(Test print)
[SET] or
[INTERRUPT]
Stores in memory
[START](Code) (Sub-code) [START]
( )
04/05