Filter
Top Products
November 2003 © TOSHIBA TEC 5 - 39 e-STUDIO3511/4511 TROUBLESHOOTING
[EAC0] Transport delay jam
MJ-1024
Is there any paper remaining on the transport path in the finisher, saddle stitcher section or equipment?
YES Remove the paper.
NO
Is the connector J708 on the finisher controller PC board disconnected?
Is the harness connecting the finisher controller PC board and inlet sensor (PI33) open circuited?
YES Connect the connector securely. Replace the harness.
NO
Is the inlet sensor working properly? (Check the movement of the actuator.)
NO 1. Connect the connector of the sensor securely.
2. Attach the actuator securely if its shaft is out of place.
3. Replace the sensor.
YES
Replace the finisher controller PC board.
(4) Paper jam in puncher unit
[E9F0] Punching jam
MJ-1023/1024
Is there any paper remaining on the transport path in the finisher or equipment?
YES Remove the paper.
NO
Is the connector J605A on the punch controller PC board disconnected?
Is the harness connecting the punch controller PC board and punch home position sensor (PI63)
open circuited?
YES Connect the connector securely. Replace the harness.
NO
Is the punch home position sensor working properly?
NO 1. Connect the connector of the punch home position sensor securely.
2. Replace the punch home position sensor.
YES
Replace the punch controller PC board.