Filter
Top Products
November 2003 © TOSHIBA TEC 5 - 75 e-STUDIO3511/4511 TROUBLESHOOTING
[CEB0] Black developer unit lifting movement abnormality
Is the black developer lifting clutch working properly? (Perform the output check: 03-433)
NO 1. Check if the connector of the black developer lifting clutch is disconnected.
2. Check if the connector CN362 on the LGC board is disconnected.
3. Check if the connector pins are disconnected or the wires of harnesses are open
circuited.
4. Check if the conductor pattern on the LGC board is short circuited or open
circuited.
5. Replace the black developer lifting clutch.
6. Replace the LGC board.
YES
Are the black developer contact position detection sensor and black developer contact timing
detection sensor working properly? (Perform the input check: 03-[FAX]ON/[1]/[C], /[1]/[B]
NO 1. Check if the connectors of the black developer contact position detection sensor
or black developer contact timing detection sensor are disconnected.
2. Check if the connector CN361 on the LGC board is disconnected.
3. Check if the connector pins are disconnected or the wires of harnesses are open
circuited.
4. Check if the conductor pattern on the LGC board is short circuited or open
circuited.
5. Replace the black developer contact position detection sensor and black devel-
oper contact timing detection sensor.
6. Replace the LGC board.
YES
1. Check if the conductor pattern on the LGC board is short circuited or open circuited.
2. Replace the LGC board.