Filter
Top Products
e-STUDIO3511/4511
ERROR CODE AND SELF-DIAGNOSTIC MODE
2 - 4 November 2003 © TOSHIBA TEC
Stop jam at the exit sensor: The trailing edge of the original
does not pass the exit sensor after its leading edge has
reached this sensor.
Stop jam at the reverse sensor: The trailing edge of the original
does not pass the reverse sensor after its leading edge has
reached this sensor.
Jam not reaching the reverse sensor (during reverse feeding):
The leading edge of the original does not reach the reverse
sensor when original is fed from the reverse section.
Jam not reaching the exit sensor (during reverse feeding): The
original does not reach the exit sensor after it has passed the
reverse sensor when the original is exited from the reverse
section.
Jam access cover open: The jam access cover has opened
during RADF operation.
RADF open jam: RADF has opened during RADF operation.
Jam at the bridge unit transport sensor 1: The paper does not
reach the bridge unit transport sensor 1 after it has passed the
exit sensor.
Stop jam at the bridge unit transport sensor 1: The trailing edge
of the paper does not pass the bridge unit transport sensor 1
after its leading edge has reached the sensor.
Jam at the bridge unit transport sensor 2: The trailing edge of
the paper does not reach the bridge unit transport sensor 2
after its leading edge has reached the bridge unit transport
sensor 1.
Stop jam at the bridge unit transport sensor 2: The trailing edge
of the paper does not pass the bridge unit transport sensor 2
after its leading edge has reached the bridge unit transport
sensor 2.
Punching jam: Punching is not performed properly.
[MJ-1023/1024 (when MJ-6004 is installed)]
Paper transport delay jam: The paper which has passed the bridge
unit does not reach the inlet sensor. [MJ-1022/1023/1024]
Paper transport stop jam:
(1) The paper does not pass through the inlet sensor.
[MJ-1022/1023/1024]
(2) The paper has passed through the inlet sensor but does not
reach or pass the feed path sensor or processing tray sensor.
[MJ-1023/1024]
Power-ON jam:
(1) Paper exists at the inlet sensor when power is turned ON.
[MJ-1022/1023/1024]
(2) Paper exists at the feed path sensor or processing tray
sensor when power is turned ON. [MJ-1023/1024]
Trouble-
shooting
Error code Classification Contents
Ch. 5.1.6
Ch. 5.1.6
Ch. 5.1.6
Ch. 5.1.6
Ch. 5.1.6
Ch. 5.1.6
Ch. 5.1.7 (1)
Ch. 5.1.7 (1)
Ch. 5.1.7 (1)
Ch. 5.1.7 (1)
Ch. 5.1.7 (4)
Ch. 5.1.7 (2)
Ch. 5.1.7 (2)
Ch. 5.1.7 (2)
RADF jam
Finisher jam
(Bridge unit)
Finisher jam
(Punch unit)
Finisher jam
(Finisher section)
E731
E741
E742
E743
E860
E870
E910
E920
E930
E940
E9F0
EA10
EA20
EA30