Filter
Top Products
e-STUDIO3511/4511 FIRMWARE UPDATING 6 - 26 November 2003 © TOSHIBA TEC
<Updating RADF ROM>
(1) Install the ROM to the download jig.
Make sure the direction is correct ( Page 6-3).
(2) Turn OFF the power of the equipment.
(3) Take off the RADF rear cover.
(4) Connect the download jig with the jig connector (CN14) on the RADF control PC board.
(5) Turn ON the power while [0] button and [8] button are pressed simultaneously.
Updating starts automatically and the LED on the download jig lights.
RADF rear cover
Connector