Filter
Top Products
e-STUDIO3511/4511 PREVENTIVE MAINTENANCE 4 - 2 November 2003 © TOSHIBA TEC
(2) Operational screen
(a) Main screen
Fig. 4-102
Displaying of the main unit name
Back to the PM support mode activation screen
Clearing of the chosen unit counters (all the sub unit (parts) counters belonging to that unit)
All counters are cleared when the unit is not selected
Moving to the sub screen
Moving to the next/previous page
Displaying of the standard number of output pages / develop counts (x1,000) to replace the
unit parts
Displaying of the present drive counts (x1,000)
“∗” is displayed next to the present number when the number of drive counts has exceeded
its PM standard number.
Displaying of the standard number of drive counts (x1,000) to replace the unit parts
Displaying of the present number of output pages/develop counts (x1,000)
When there are differences among the sub units (parts), “_” is displayed and “CHECK
SUBUNIT” is displayed at the top
“∗” is displayed next to the present number when the number of output pages or develop
counts has exceeded its PM standard number.
Displaying of the number of output pages / develop counts (Page/D. cnt), drive counts (Cnt.)
and previous replacement date (Chg.) for a chosen unit
When the replacement date for the sub unit is different, press the [SUB UNIT] button to
move to the sub screen and see each information, otherwise information is not displayed
Notes:
1. “—” is always displayed at the drive counts section for the reversing automatic document
feeder (RADF) and feed unit.
2. “—” is displayed at the numeric section for the paper source which is not installed since the
paper source is different depending on the structure of options.
1
234 5 6
910
78