Filter
Top Products
e-STUDIO3511/4511 FIRMWARE UPDATING 6 - 20 November 2003 © TOSHIBA TEC
6.1.3 Writing the data to the download jig (PWA-DWNLD-350-JIG)
The download jig (PWA-DWNLD-350-JIG) differs from the existing jigs in that the Flash ROM is mounted
on the board of the jig directly. The ROM writer adapter (PWA-DL-ADP-350) is required to write data to
these Flash ROMs. Connect the download jig with the ROM writer via ROM writer adapter to write data.
For the procedure to write data, refer to the download procedure, instruction manual of each ROM writer,
or others.
Note:
There are two types of the ROM writer adapter. Use the proper one according to the ROM writer to be
used. Applicable type of the adapter for the ROM writer can be confirmed by the model name indicated on
the board. Confirm that the adapter is available for the ROM writer to be used before connecting them. If
an unapplied adapter is connected, the application of the ROM writer judges it as an error and writing the
data cannot be implemented. Applicable combinations of the ROM writer and adapter are as follows.
ROM writer
Minato Electronics MODEL 1881XP
(or equivalent)
Minato Electronics MODEL 1893/1895/1931/1940
(or equivalent)
[PWA-DL-ADP-350-1881]
ROM writer adapter
PWA-DL-ADP-350-1881
(model 1881)
PWA-DL-ADP-350-1931
(model 1931)
[PWA-DL-ADP-350-1931]
model 1931
(
LV650
)
model 1881
model 1931
(
LV650
)
model 1881
PC
Download jig
(PWA-DWNLD-350-JIG)
ROM writer adapter
(PWA-DL-ADP-350)
ROM writer