Filter
Top Products
e-STUDIO3511/4511 FIRMWARE UPDATING 6 - 28 November 2003 © TOSHIBA TEC
* Connect the finisher interface cable with the equipment after removing the finisher rear cover.
(4) Connect the download jig with the jig connector on the finisher control PC board.
[MJ-1023] [MJ-1024]
Finisher rear cover Finisher rear cover
Connector
<Updating Finisher ROM>
Finisher firmware (MJ-1023/1024) and saddle stitcher firmware (MJ-1024 only) are written on the
finisher ROM. These two kinds of firmware can be updated individually by installing the download jig
to the finisher control PC board.
Tip:
The following updates are needed according to the finisher model.
• MJ-1023 (Console type):
Only the update of “Finisher firmware” is needed.
• MJ-1024 (Console type with the saddle stitcher):
Two kinds of update “Finisher firmware” and “Saddle stitcher firmware” are needed.
(1) Install the ROM to the download jig.
Make sure the direction is correct ( Page 6-3).
(2) Turn OFF the power of the equipment.
(3) Take off the finisher rear cover.