Filter
Top Products
November 2003 © TOSHIBA TEC 2 - 31 e-STUDIO3511/4511
ERROR CODE AND SELF-DIAGNOSTIC MODE
2.2.3 Test print mode (test mode 04)
The embedded test pattern can be printed out by keying in the following codes in the test print
mode (04).
<Procedure 1>
Code
142
204
219
220
231
237
262
270
[0][4]
[POWER]
[POWER] OFF/ON
(Exit)
(Code)
[START]
Operation
Continuous
test printing
[CLEAR]
()
Notes:
1. When an error occurs, it is indicated on the panel, but the recovery operation is not performed.
Turn OFF the power and then back ON to clear the error.
2. During test printing, the [CLEAR] button is disabled when “Wait adding toner” is displayed.
<Procedure 2>
[0][4]
[POWER]
[POWER] OFF/ON
(Exit)
(Code) Color
selection
[START]
[START]
[CLEAR]
[CLEAR]
Operation
Continuous
test printing
(
(
(
)
Remarks
1
2
2
2
2
2
2
2
Types of test pattern
Grid pattern (black)
Grid pattern (color)
6% test pattern
8% test pattern
Secondary scanning direction 33 gradation steps
Halftone
Pattern for jitter evaluation (4 lines ON / 4 lines OFF)
Image quality control test pattern
Remarks
Pattern width: 2 dots, Pitch: 10 mm
Pattern width: 1 dot, Pitch: 10 mm
3 pixels standard, Width: 10 mm
1 pixel standard, for color deviation
correction
For checking the image quality
control