Filter
Top Products
e-STUDIO3511/4511 ADJUSTMENT 3 - 96 November 2003 © TOSHIBA TEC
(13) Open the 2nd transfer unit cover to check the transfer belt deviation. (See 3.16.2)
After the checking, continue the adjustment according to the following items A to C.
• Result A
The direction of the transfer belt deviation is the same as before the adjustment and the gap is
0.2 mm or less:
Return to step (7) to readjust it. If the same result is obtained after adjusting it 3 times, replace
the transfer belt unit.
• Result B
The direction of the transfer belt deviation moves to the opposite side and the gap is 0.2 mm
or less:
Return to step (7) to readjust it. The rotation amount of the adjustment screw should be two-
sixth turn because the one in step (9) is for the 2nd adjustment. If the adjustment is performed
3 times or more, it should be one-sixth turn.
• Result C
Neither Result A nor B:
Go to the next step (14).
(14) Install the drum cleaner unit and the black developer unit (do not connect 2 connectors of the
black developer unit), and then perform step (12).
Note:
Be sure to disconnect 2 connectors of the black developer unit in advance.
(15) Open the 2nd transfer unit cover to check the transfer belt deviation. (See 3.16.2)
If no problem is found, go to step (16).
If any problem is found, perform steps (2) to (11) and (14). At this time, the rotation amount of the
adjustment screw should be one-sixth turn.
(16) Connect the connector of the black developer unit and install all covers to complete the
adjustment.
05/03