Filter
Top Products
November 2003 © TOSHIBA TEC 3 - 37 e-STUDIO3511/4511 ADJUSTMENT
Code
663
Remarks
The smaller the value is, the dot size becomes smaller.
Acceptable values: 0 to 255. (Default: 255)
<Adjustment Mode (05)>
3.6.6 Dot size adjustment in black printing
The dot size is adjusted in primary scanning direction in black printing.
<Procedure>
Procedure is same as that of “3.6.2 Gamma balance adjustment”.
Note:
The larger the value is, the more frequently fusing offsetting occurs.
3.6.8 Image processing: Gamma correction table all clearing
The state of calibration in color printing mode is initialized at the Setting Mode (08-597). This setting is to
be performed when a defect occurs in “Automatic gamma adjustment (05-1000 to 1003)”. The cause of
defect is presumed as an image failure (jittering or uneven image density) at the patch chart for gamma
adjustment.
<Procedure>
Procedure is same as that of “3.6.4 Adjustment of smudged/faint text”.
3.6.7 Maximum toner density adjustment to paper type
The maximum toner amount adhering to the paper can be controlled.
PS
1046-0
1047-0
1048-0
1049-0
1050-0
Remarks
The smaller the value is, the toner amount adhered decreases of the
high density area (ex. prevention of fusing offsetting, etc).
Acceptable values: 0 to 255. (Default: Plain paper: 255, Thick paper 1:
255, Thick paper 2: 255, Thick paper 3: 255, OHP film: 200)
PCL
1046-1
1047-1
1048-1
1049-1
1050-1
<Adjustment Mode (05)>
Paper type
Plain paper
Thick paper 1
Thick paper 2
Thick paper 3
OHP film
Code