Filter
Top Products
November 2003 © TOSHIBA TEC 3 - 13 e-STUDIO3511/4511 ADJUSTMENT
(g) Primary scanning data laser writing start position at duplexing
Note:
Make sure the first line of the grid pattern is printed out since the line is occasionally vanished.
(g-1) Adjustment for long-sized paper
1. While pressing [0] and [5] simultaneously, turn the power ON. → (Adjustment Mode)
2. Press [3] → [FAX]. (A grid pattern with 10 mm squares is printed out. Use A3/LD from the lower
drawer.)
3. Check the grid pattern on the test print and measure the distance E from the left edge of the
paper to the 6th line of the grid pattern.
4. Check if the distance E is within 52±0.5 mm.
5. If not, use the following procedure to change values and measure the distance E again.
<Procedure> (Adjustment Mode) → (Key in the code [498]) → [START] → [0] → [START]
→ (Key in a value (acceptable values: 0 to 255))
→ [ENTER] or [INTERRUPT] (Stored in memory)
→ "100% A" is displayed.
→ Press [3] → [FAX] → (A grid pattern is printed out.)
** The larger the adjustment value is, the longer the distance E becomes (approx.
0.04 mm/step).
(g-2) Adjustment for short-sized paper
1. While pressing [0] and [5] simultaneously, turn the power ON. → (Adjustment Mode)
2. Press [3] → [FAX]. (A grid pattern with 10 mm squares is printed out. Use A4/LT from the upper
drawer.)
3. Check the grid pattern on the test print and measure the distance E from the left edge of the
paper to the 6th line of the grid pattern.
4. Check if the distance E is within 52±0.5 mm.
5. If not, use the following procedure to change values and measure the distance E again.
<Procedure> (Adjustment Mode) → (Key in the code [498]) → [START] → [1] → [START]
→ (Key in a value (acceptable values: 0 to 255))
→ [ENTER] or [INTERRUPT] (Stored in memory)
→ "100% A" is displayed
→ Press [3] → [FAX] → (A grid pattern is printed out.)
* The larger the adjustment value is, the longer the distance E becomes (approx.
0.04 mm/step).
04/02