Filter
Top Products
November 2003 © TOSHIBA TEC 3 - 47 e-STUDIO3511/4511 ADJUSTMENT
(2) Adjusting carriages-1 and -2 positions
a. Move the carriage-2 toward the exit side.
b. Loosen the screws fixing the front side pulley bracket, make the sections A and B of the
carriage-2 touch with the inside of the exit side frame and screw them up.
Fig. 3-902
c. Put the carriage-1 on the rail, make the sections C and D of it touch with the inside of the exit
frame and screw up the front/rear side of the bracket to fix it.
Note:
Make sure that the sections A and B of the carriage-2 touch with the exit side frame.
Carriage-2 Pulley bracket
Exit side frame
B
A
Carriage-1
Exit side frame
D
C
Bracket Bracket
[Rear] [Front]
[Rear] [Front]
Enlarged view of carriage
Enlarged view of carriage
Fig. 3-903