Filter
Top Products
28/28 BCN-C22005-675
12 Support for the PU operation mode of the brake sequence
function
The brake sequence function is enabled when either the PU operation mode or the External/PU combined operation mode
2 is selected.
13 Parameter for manufacturer setting
• Pr. 414 to Pr. 417, Pr. 498, Pr. 506 to Pr. 515 are parameters for manufacturer setting. Do not set.
• The setting value "50" of Pr. 178 to Pr. 189 (input terminal function selection) is for manufacturer setting. Do not set.
REMARKS
If the X75 signal is turned ON while the inverter is running and remains ON, the X75 signal will be valid after the
inverter stops.
If the inverter is reset by turning ON the RES signal while the converter operation is stopped by the X75 signal, the
converter stopped status is retained even while the reset is being processed.
Disabled
Inverter status
During stop During running Output shutoff
Power RegenerativePower/regenerative driving status
X75 OFF
ON
STF OFF
ON
Bus voltage
Protective function activation
Time
Converter operation Enabled
bcnc22005635.fm 28 ページ ２０１４年１２月１１日 木曜日 午後５時５９分