Filter
Top Products
89
Start/stop from the operation panel (PU
operation mode)
4
DRIVING THE MOTOR
Change the frequency (60Hz) of the maximum value of potentiometer (at 5V, initial value)
Adjust the frequency in Pr. 125 Terminal 2 frequency setting gain frequency. (Refer to page 97.)
Change the frequency (0Hz) of the minimum value of potentiometer (at 0V, initial value)
Adjust the frequency in calibration parameter C2 Terminal 2 frequency setting bias frequency. (Refer to
Chapter 4 of the Instruction Manual (Applied).)
11. Stop
Press .
[FWD]
indicator
or [REV] indicator turns OFF.
Stop
Flickering
DisplayOperation
10.
Deceleration
Turn the potentiometer (frequency setting
potentiometer) counterclockwise slowly to full.
The frequency on the display decreases
in Pr. 8 Deceleration time, and the motor stops
rotating with " " (0.00Hz) displayed.
[FWD] indicator or [REV] indicator flickers.