Filter
Top Products
55
Operation panel (FR-DU07)
4
DRIVING THE MOTOR
(2) Parameter verification
appears...Why? Parameter read error. Perform operation from step 3 again.
appears...Why? Parameter write error. Perform operation from step 8 again.
Whether same parameter values are set in other inverters or not can be checked.
flickers ... Why?
Set frequencies, etc. may be different. Check set frequencies.
• Hold down to verify.
2.Screen at power-ON
The monitor display appears.
Display
Operation
7.Press to read the parameter setting
of the verified inverter to the operation panel.
1.Move the operation panel to the
inverter to be verified.
• Move it during a stop.
Flicker ··· Parameter verification complete!!
4.Turn until (parameter copy)
appears.
6.Turn to change it to the set value
" "(parameter copy verification mode).
8.It there is no difference, " " and " "
flicker to complete verification.
Flickers for about 30s
Flickering
• If different parameters exist, different
parameter numbers and flicker.
The parameter
number read
previously appears.
5.Press to read the currently set
value.
" "(initial value) appears.
3.Press to choose the parameter
setting mode.