Filter
Top Products
176
No. Access Attribute Default Setting
214 Get/Set Pr. 234 Multi-Speed Setting (Speed 10) (Note 3)
215 Get/Set Pr. 235 Multi-Speed Setting (Speed 11) (Note 3)
216 Get/Set Pr. 236 Multi-Speed Setting (Speed 12) (Note 3)
217 Get/Set Pr. 237 Multi-Speed Setting (Speed 13) (Note 3)
218 Get/Set Pr. 238 Multi-Speed Setting (Speed 14) (Note 3)
219 Get/Set Pr. 239 Multi-Speed Setting (Speed 15) (Note 3)
220 Get/Set Pr. 240 Soft-PWM Setting 1
224 Get/Set Pr. 244 Cooling Fan Operation Selection 0
225 Get/Set Pr. 245 Rated Motor Slip (Note 3)
226 Get/Set Pr. 246 Slip Compensation Response Time 0.5s
227 Get/Set
Pr. 247 Constant-Output Region Slip Compensation
Selection
(Note 3)
229 Get/Set Pr. 249 Ground Fault Detection at Start 0
230 Get/Set Pr. 250 Stop Selection (Note 3)
Note: 1. Parameters marked “Special” should not be changed under normal operating
conditions. Improper inverter operation and damage to equipment may occur.
Contact technical support for further information
2. Some default settings depend on the capacity or type of the inverter.
3. The default settings 65535, 6553.5 and 655.35 indicate that the function is
invalid. These settings will be "9999" when viewed via the parameter unit.
4. Changing the value of No. 31 will change the setting increments of the inverter
but this will not be reflected on DeviceNet
TM
.
(4) Class 0x66 Instance Services
Service Code Service
0x0E Get Attribute Single
0x10 Set Attribute Single