Filter
Top Products
48
(2) Changing Node Addresses
The state of the node address is sampled once at power on. Changing the address
later on will have no effect and the software will keep the number read at power on.
The following procedure explains how to change the Node address switches:
1) Turn power to the inverter off.
2) Remove the inverter cover.
3) Disconnect drop cable from inverter unit.
4) Set the Node address (rotary switches) as desired.
5) Reconnect the drop cable to the inverter unit.
6) Reinstall inverter cover.
7) Turn inverter power back on.
3