Filter
Top Products
91
Operation selection functions 1 (Pr. 17 to Pr. 37)
PARAMETERS
3
Pr. 29 = 4 (S-pattern acceleration/deceleration C)
With the S-pattern acceleration/deceleration C switch signal (X20), an acceleration/deceleration curve S-pattern 1
or S-pattern 2 can be selected.
As the acceleration/deceleration time during acceleration/deceleration, set the percentage to the acceleration/
deceleration time T in Pr. 380 to Pr. 383.
Parameter setting (%) = Ts / T ×100%
Operation
During Acceleration During Deceleration
X20 Signal
OFF Pr. 380 "acceleration S pattern 1" Pr. 381 "deceleration S pattern 1"
ON Pr. 382 "acceleration S pattern 2" Pr. 383 "deceleration S pattern 2"
REMARKS
• At a start, the motor starts at Pr. 13 "starting speed" when the start signal turns on.
• If there is a difference between the speed command and speed at a start of deceleration due to torque limit operation etc.,
the speed command is matched with the speed to make deceleration.
Related parameters
• Base frequency setting (acceleration/deceleration time setting) ⇒ Pr. 3 "base frequency" (Refer to page 77.)
• Pr. 20 "acceleration/deceleration reference speed"
⇒ Refer to page 78.
• X20 signal setting when Pr. 29 = 4 (S-pattern acceleration/deceleration switch)
⇒ Pr. 180 to Pr. 187 (input terminal function
selection) (Refer to page 150.)
• Starting speed setting
⇒ Pr. 13 "starting speed" (Refer to page 84.)
Pr.380
Pr.381
OFF
OFF
Pr.382
Pr.382
Pr.383
Pr.383
ON
ON
Pr.380
Pr.381
S-pattern C switch
(X20)
Set speed
CAUTION
Change the S pattern acceleration/
deceleration C switch (X20) after the speed
becomes constant. S pattern operation
before switching continues even if the X20 is
changed during acceleration or
deceleration.
S-pattern acceleration
Linear acceleration
Ts
T
Ts