Filter
Top Products
150
Display function 3 (Pr. 160)
3.18 Display function 3 (Pr. 160)
3.18.1 Extended function display selection (Pr. 160 )
3.19 Initial monitor (Pr. 171)
3.19.1 Actual operation hour meter clear (Pr. 171 )
<Setting>
Write "0" in the corresponding parameter to clear the actual operation hour.
3.20 Terminal assignment functions (Pr. 180 to Pr. 195)
3.20.1 Input terminal function selection
(Pr. 180 to Pr. 183, Pr. 187 )
Used to display the extended function parameters.
z Refer to page 66 for the extended function parameter list.
Parameter Name
Factory
Setting
Setting
Range
Remarks
160
Extended function
selection
0
0 Only the simple mode parameters are accessible.
1 All parameters are accessible.
Pr. 162 to Pr. 165 Refer to Pr. 57 (page 101).
You can clear the actual operation hour of the monitoring function.
Parameter Name Factory Setting Setting Range
171
Actual operation hour
meter clear
00
REMARKS
The actual operation time is the value monitored by setting "23" in Pr. 52.
Related parameters
• Pr. 52 "DU/PU main display data selection" (Refer to page 97.)
Use these parameters to select/change the input terminal functions.
Parameter Name
Terminal
Symbol
Factory-
Set Value
Factory-Set Terminal
Function
Setting
Range
Remarks
180
DI1 terminal
function
selection
DI1 0
Low speed operation
command (RL)
0 to 3, 5, 8 to
12,14 to 16,
20, 22 to 28,
42 to 44,
9999
9999: No function
Extended
mode
181
DI2 terminal
function
selection
DI2 1
Middle speed
operation command
(RM)
182
DI3 terminal
function
selection
DI3 2
High speed operation
command (RH)
183
DI4 terminal
function
selection
DI4 3
Second function/
second motor
switchover (RT)
187
STR
terminal
function
selection
STR 9999
Reverse rotation
command (STR)
9999: STR
speed torque position
speed torque position
speed torque position