Filter
Top Products
Corrective Maintenance
CSA 803C Service Manual
6Ć13
Some applications of the CSA 803C may require that the power remain on.
To electrically lock the power on, use the following procedure:
ăStep 1:ăSwitch the rear panel PRINCIPAL POWER SWITCH to OFF.
ăStep 2:ăRemove the AC power cable.
ăStep 3:ăPosition the instrument on its left (handle) side, as viewed from
the front.
ăStep 4:ăRemove the bottom cover.
ăStep 5:ăLocate the A4 Regulator board.
ăStep 6:ăLocate the J820 jumper on the A4 Regulator board.
ăStep 7:ăReposition the J820 jumper from its two outer (right side) pins
to its two inner (left side) pins, without dropping the jumper.
ăStep 8:ăReplace the bottom cover. Turn the instrument in the upright
position.
ăStep 9:ăReconnect the AC power cable and switch the PRINCIPAL
POWER SWITCH to ON.
The power will now remain on regardless of the setting of the ON/
STANDBY power switch.
CAUTION
To prevent damage to the instrument and/or sampling head, do not
install or remove a sampling head while the power is on.
ăStep 10:ăTo turn the power off while the ON/STANDBY power switch is
disabled, use the rear panel PRINCIPAL POWER SWITCH.
To return to normal operation of the ON/STANDBY Power Switch, follow the
preceding steps in reverse order.
Electrical LockĆOn of
the Front Panel
ON/STANDBY Power
Switch