xStack
®
DGS-3600 Series Layer 3 Gigabit Ethernet Managed Switch CLI Manual
111
14
BORDER GATEWAY PROTOCOL (BGP) COMMANDS
The Border Gateway Protocol (BGP) commands in the Command Line Interface (CLI) are listed (along with the
appropriate parameters) in the following table.
Command Parameters
enable bgp
disable bgp
create bgp
<as_number 1
-65535>
delete bgp <as_number 1-65535>
config bgp router_id <ipaddr>
config bgp synchronization [enable | disable]
config bgp enforce_first_as [enable | disable]
create bgp aggregate_address <network_address> {summary_only | as_set}
delete bgp aggregate_address [<network_address>| all]
show bgp aggregate_address {<network_address>]
create bgp network <network_address> {route_map <map_name 16>}
config bgp network <network_address> [route_map <map_name 16> | clear_routemap]
delete bgp network [<network_address> | all]
show bgp network {<network_address>}
config bgp timer holdtime <sec 0-65535> keepalive <sec 0-65535>
config bgp { always_compare_med [enable | disable]| deterministic_med [enable | disable] |
default_local_preference <uint 0-4294967295>| bestpath { as_path_ignore
[enable | disable] | compare_routerid [enable | disable] | med_confed [enable |
disable] | med_missing_as_worst [enable | disable] | compare_confed_aspath
[enable | disable] }(1)}(1)
config bgp dampening [ route_map <map_name 16> | clear_routemap | { state [enable | disable] |
half_life <min 1-45 > | reuse<value 1-20000> | suppress <value 1-20000> |
max_suppress_time <min 1-255 >| un_reachability_half_life <min 1-45>}(1)]
show bgp dampening
config bgp peer_group <peer_group_name 16> [add | delete] <ipaddr>
config bgp peer_group
<peer_group_name 16> remote_as <as_number 0
-65535>
create bgp neighbor
[<ipaddr> [remote_as <as_number 1
-65535>| peer_group <peer_group_name
16>] | peer_group <peer_group_name 16>]
delete bgp neighbor [<ipaddr> | peer_group <peer_group_name 16> | all]
config bgp neighbor
description
[<ipaddr> | peer_group <peer_group_name 16>] [descrip
tion <desc 80> | clear_description]
config bgp neighbor session
[<ipaddr> | peer_group <peer_group_name 16>] state [enable | disable]
config bgp neighbor session [<ipaddr> | peer_group <peer_group_name 16>] activity [enable | disable]
