xStack
®
DGS-3600 Series Layer 3 Gigabit Ethernet Managed Switch CLI Manual
519
debug ospf interface_state_change
change.
Parameters
dr_bdr_selection - Used to include or exclude debug information for DR/BDR selection.
state - The state of the OSPF interface state change debug.
Restrictions Only Administrator level users can issue this command.
Example usage:
To enable OSPF interface state change debug:
DGS-3627:admin# debug ospf interface_state_change state enable
Command: debug ospf interface_state_change state enable
Success.
debug ospf lsa
Purpose Used to enable or disable debug information flags about LSA.
Syntax
debug ospf lsa {all | originating | installing | receiving | flooding} state [enable |
disable]
Description This command is used to enable or disable debug information flags about LSA.
Parameters
all - Set all LSA debug flags.
originating - Set LSA originating debug flag.
installing - Set LSA installing debug flag.
receiving - Set LSA receiving debug flag.
flooding - Set LSA flooding debug flag.
state - The state of the designated debug flag.
Restrictions Only Administrator level users can issue this command.
Example usage:
To enable all OSPF LSA debug flags:
DGS-3627:admin# debug ospf lsa all state enable
Command: debug ospf lsa all state enable
Success.
debug ospf packet
Purpose Used to enable or disable debug information flags about packets, including receiving and
sending.
Syntax
debug ospf packet {all | receiving | sending} state [enable | disable]
Description This command is used to enable or disable debug information flags about packets, including
receiving and sending.
Parameters
all - Set all packet debug flags.
receiving - Set packet receiving debug flag.
