xStack
®
DGS-3600 Series Layer 3 Gigabit Ethernet Managed Switch CLI Manual
641
show snmp v6host
Note: This is SNMPv3 command, if it is used; All SNMPv1/v2 commands are not necessary.
Parameters
v6host - Specifies the IPv6 host address.
If no parameter specified, all SNMP hosts will be displayed.
Restrictions None.
Example usage:
To show SNMP host:
DGS-3627:admin# show snmp v6host
Command: show snmp v6host
SNMP Host Table
------------------------------------------------------------------
Host IPv6 Address : 3FFE::3
SNMP Version : V3 na/np
Community Name/SNMPv3 User Name : initial
Host IPv6 Address : 3FFE::2
SNMP Version : V2c
Community Name/SNMPv3 User Name : private
Host IPv6 Address : 3FFE::1
SNMP Version : V1
Community Name/SNMPv3 User Name : public
Host IPv6 Address : 3FFE::3
SNMP Version : V3 a/np
Community Name/SNMPv3 User Name : user123
Host IPv6 Address : 3FFE::3
SNMP Version : V3 a/ p
Community Name/SNMPv3 User Name : user234
Total Entries: 5
config snmp engineID
Purpose This command is used to configure a identifier for the SNMP engine on the switch.
Syntax
config snmp engineID <snmp_engineID>
Description The config snmp engineID command configures an identifier for the SNMP engine on the
switch. Associated with each SNMP entity is a unique engineID.
Note: This is SNMPv3 command, if it is used; All SNMPv1/v2 commands are not necessary.
Parameters
snmp_engineID - Identify for the SNMP engine on the switch. It is octet string type. It accepts
the hex number directly.
Restrictions Only Administrator and Operator-level users can issue this command.
Example usage:
To configure SNMP engine ID to “1023457890”:
