xStack
®
DGS-3600 Series Layer 3 Gigabit Ethernet Managed Switch CLI Manual
654
show subnet_vlan
VLAN entries will be displayed.
ipv6network - To specify an IPv6 network address. If network address is not specifed, all
subnet VLAN entries will be displayed.
vlan - If specify the vlan, all subnet vlan entries that associated with this vlan will be
displayed. If no parameter is specified, all subnet vlan entries will be displayed.
vidlist - Specifies a list of VLANs by VLAN ID.
Restrictions None.
Example usage:
This example shows how to show a specified subnet VLAN entry:
DGS-3627:admin# show subnet_vlan network 172.168.1.0/24
Command:show subnet_vlan network 172.168.1.0/24
IP Address/Subnet Mask VLAN Priority
-------------------------- ------ ---------
172.168.1.0/255.255.255.0 10 2
This example shows how to display a specified IPv6 subnet VLAN entry:
DGS-3627:admin# show subnet_vlan ipv6network FE80::/64
Command: show subnet_vlan ipv6network FE80::/64
IP Address/Subnet Mask VLAN Priority
---------------------------- ------ ---------
fe80::/64 10 2
This example shows how to show all subnet VLAN entries:
DGS-3627:admin# show subnet_vlan
Command:show subnet_vlan
IP Address/Subnet Mask VLAN Priority
--------------------------- ------ -----------
172.168.1.0/255.255.255.0 10 2
172.18.211.0/255.255.255.0 20 3
fe80::/64 10 2
Total Entries : 3
config vlan_precedence ports
Purpose Use this command to configure the vlan classification precedence.
Syntax
config vlan_precedence ports <portlist> [mac_based_vlan | subnet_vlan]
Description This command is used to configure vlan classification precedence on each port.
You can specify the order of MAC-based VLAN classification and subnet VLAN classification.
If a port’s VLAN classification is MAC-based precedence, MAC-based VLAN classification
