xStack
®
DGS-3600 Series Layer 3 Gigabit Ethernet Managed Switch CLI Manual
254
32
DOMAIN NAME SERVER (DNS)RELAY COMMANDS
The Domain Name Server (DNS) relay commands in the Command Line Interface (CLI) are listed (along with the
appropriate parameters) in the following table.
Command Parameters
config dnsr [[primary | secondary] nameserver <ipaddr> | [add | delete] static
<domain_name 32> <ipaddr>]
enable dnsr {[cache | static]}
disable dnsr {[cache | static]}
show dnsr {static}
Each command is listed, in detail, in the following sections.
config dnsr
Purpose Used to configure the DNS relay function.
Syntax
config dnsr [[primary | secondary] nameserver <ipaddr> | [add | delete] static
<domain_name 32> <ipaddr>]
Description This command is used to configure the DNS relay function on the Switch.
Parameters
primary − Indicates that the IP address below is the address of the primary DNS server.
secondary − Indicates that the IP address below is the address of the secondary DNS server.
nameserver <ipaddr> − The IP address of the DNS nameserver.
[add | delete] – Indicates whether to add or delete the DNS relay function.
<domain_name 32> − The domain name of the entry.
<ipaddr> − The IP address of the entry.
Restrictions Only Administrator and Operator-level users can issue this command.
Example usage:
To set IP address 10.43.21.12 of primary.
DGS-3627:admin# config dnsr primary nameserver 10.43.21.12
Command: config dnsr primary nameserver 10.43.21.12
Success
Example usage:
To add an entry domain name dns1, IP address 10.43.21.12 to DNS static table:
