xStack
®
DGS-3600 Series Layer 3 Gigabit Ethernet Managed Switch CLI Manual
683
93
TELNET CLIENT COMMANDS
The Telnet Client commands in the Command Line Interface (CLI) are listed (along with the appropriate parameters) in
the following table.
Command Parameters
telnet [<ipaddr> | <domain_name 255>] {tcp_port(1) <value 0-65535>}
Each command is listed, in detail, in the following sections.
telnet
Purpose Used to initiate a Telnet client session with a specific Telnet server.
Syntax
telnet [<ipaddr> | <domain_name 255>] {tcp_port(1) <value 0-65535>}
Description The Telnet command establishes a single Telnet client connection with a specified server.
The parameters specified by the command will only be used for the establishment of this
specific session. They will not affect the establishment of other sessions.
Parameters
ipaddr - The IP address of the Telnet server.
domain_name - Specify the domain name of the Telnet server.
tcp_port - Specifies the Telnet server port number to be connected. If not specified, the
default port is 23.
Restrictions None.
Example usage:
Telnet to a Switch by specifying the IP address:
DGS-3627:admin# telnet 10.90.90.90
Command: telnet 10.90.90.90
DGS-3627 Fast Ethernet Switch Command Line Interface
Firmware: Build 1.01-B03
Copyright(C) 2006-2010 D-Link Corporation. All rights reserved.
UserName:
Telnet to a host by specifying the domain name and the server port:
DGS-3627:admin# telnet ctrl.iplanet.org tcp_port 2323
Command: telnet ctrl.iplanet.org tcp_port 2323
