xStack
®
DGS-3600 Series Layer 3 Gigabit Ethernet Managed Switch CLI Manual
550
Command Parameters
enable pim
disable pim
config pim [[ipif <ipif_name 12> | all] {hello <sec 1-18724> | jp_interval <sec 1-18724> |
state [enable | disable] | mode [dm | sm | sm-dm] | dr_priority <unit 0 –
4294967294>} | register_probe_time <value 1-127> |
register_suppression_time <value 3-255>]
create pim crp group <network_address> rp <ipif_name 12>
delete pim crp group <network_address>
config pim crp {holdtime <value 0-255> | priority <value 0-255> | wildcard_prefix_cnt [0 | 1]}
create pim static_rp group <network_address> rp <ipaddr>
delete pim static_rp group <network_address>
show pim static_rp
config pim last_hop_spt_switchover [never | immediately]
show pim rpset
show pim crp
config pim cbsr [ipif <ipif_name 12> {priority [-1 | <value 0-255>]} | hash_masklen <value 0-
32> | bootstrap_period <value 1-255>]
show pim cbsr {ipif <ipif_name 12>}
show pim {ipif <ipif_name 12>}
show pim neighbor {ipif <ipif_name 12> | ipaddress <network_address>}
show pim ipmroute
create pim
register_checksum_include_data
rp_address
<ipaddr>
delete pim
register_checksum_include_data
rp_address
<ipaddr>
show pim
register_checksum_include_data_rp_list
Each command is listed, in detail, in the following sections.
enable pim
Purpose Used to enable the PIM function on the Switch.
Syntax
enable pim
Description This command will enable PIM for the Switch.
Parameters None.
Restrictions Only Administrator and Operator-level users can issue this command.
Example usage:
To enable PIM as previously configured on the Switch:
