A SERVICE OF

logo

xStack
®
DGS-3600 Series Layer 3 Gigabit Ethernet Managed Switch CLI Manual
306
DGS-3627:admin#enable qinq
Command: enable qinq
Success.
DGS-3627:admin#
disable qinq
Purpose Used to disable the QinQ.
Syntax
disable qinq
Description When QinQ is disabled, all dynamic learned L2 address will be cleared, all dynamic
registered VLAN entries will be cleared, and GVRP will be disabled.
If need to run GVRP on the switch, administrator should enable GVRP manually.
Parameters None.
Restrictions Only Administrator and Operator-level users can issue this command.
Example usage:
To disable qinq:
DGS-3627:admin# disable qinq
Command: disable qinq
Success.
DGS-3627:admin#
show qinq
Purpose Used to show global QinQ status.
Syntax
show qinq
Description Use this command to display the global QinQ status.
Parameters None.
Restrictions None.
Example usage:
To show qinq:
DGS-3627:admin# show qinq
Command: show qinq
QinQ Status: Enable
Success.
DGS-3627:admin#