xStack
®
DGS-3600 Series Layer 3 Gigabit Ethernet Managed Switch CLI Manual
499
show ospfv3 virtual_link
Syntax
show ospfv3 virtual_link {<area_id> <neighbor_id>}
Description This command is used to display OSPFv3 virtual link configuration. If no parameters are set,
all virtual links will be displayed.
Parameters
<area_id> - A 32-bit number in the form of an IPv4 address that uniquely identifies the
OSPFv3 area in the OSPFv3 domain. This area is the transit area where the virtual link is
built.
<neighbor_id> - A 32-bit number in the form of an IPv4 address that uniquely identifies the
OSPFv3 virtual neighbor in the OSPFv3 domain.
Restrictions None.
Example usage:
To display OSPFv3 virtual link:
DGS-3627:admin# show ospfv3 virtual_link
Command: show ospfv3 virtual_link
Virtual Interface Configuration
Transit Virtual Hello Dead Instance ID Link
Area ID Neighbor Router Interval Interval Status
--------------- --------------- -------- -------- ----------- ------
1.1.1.1 60.60.60.60 10 60 0 DOWN
1.1.1.1 70.70.70.70 10 60 0 DOWN
Total Entries: 2
DGS-3627:admin# show ospfv3 virtual_link 1.1.1.1 60.60.60.60
Command: show ospfv3 virtual_link 1.1.1.1 60.60.60.60
Transit Area ID: 1.1.1.1 Virtual Neighbor Router ID: 60.60.60.60
Hello Interval: 10 Dead Interval: 60
Transmit Delay: 1 Retransmit Time: 5
Instance ID: 0
Virtual Link Status: DOWN
Total Entries: 1
