xStack
®
DGS-3600 Series Layer 3 Gigabit Ethernet Managed Switch CLI Manual
725
103
VLAN TRUNKING COMMANDS
The VLAN Trunking commands in the Command Line Interface (CLI) are listed (along with the appropriate parameters) in
the following table.
Command Parameters
enable vlan_trunk
disable vlan_trunk
config vlan_trunk ports [<portlist> | all] | state [enable | disable]
show vlan_trunk
Each command is listed, in detail, in the following sections.
enable vlan_trunk
Purpose Used to enable the VLAN trunk function.
Syntax
enable vlan_trunk
Description When the VLAN trunk function is enabled, the VLAN trunk ports shall be able to forward all
tagged frames with any VID.
Parameters None.
Restrictions Only Administrator can issue this command.
Example usage:
To enable the VLAN Trunk:
DGS-3627:admin# enable vlan_trunk
Command: enable vlan_trunk
Success.
disable vlan_trunk
Purpose Used to disable the VLAN trunk function.
Syntax
disable vlan_trunk
Description This command disables the VLAN trunk function.
Parameters None.
Restrictions Only Administrator can issue this command.
Example usage:
To disable the VLAN Trunk:
