xStack
®
DGS-3600 Series Layer 3 Gigabit Ethernet Managed Switch CLI Manual
728
104
VRRP DEBUG COMMANDS
The VRRP Debug commands in the Command Line Interface (CLI) are listed (along with the appropriate parameters) in
the following table.
Command Parameters
debug vrrp show flag
debug vrrp vr_state_change state [enable | disable]
debug vrrp packet [all | {receiving | sending}(1)] state [enable | disable]
debug vrrp mac_addr_update state [enable | disable]
debug vrrp interface_change state [enable | disable]
debug vrrp timers state [enable | disable]
debug vrrp show counter
debug vrrp clear counter
debug vrrp log state [enable | disable]
debug vrrp show log state
debug vrrp state [enable | disable]
Each command is listed, in detail, in the following sections.
debug vrrp show flag
Purpose Used to display VRRP debug flag settings.
Syntax
debug vrrp show flag
Description This command is used to display VRRP debug flag settings.
Parameters None.
Restrictions Only Administrator level users can issue this command.
Example usage:
To display VRRP debug flag settings:
DGS-3627:admin# debug vrrp show flag
Command: debug vrrp show flag
Current VRRP Debug Level Settings
Virtual Router State Change
Packet Sending
