xStack
®
DGS-3600 Series Layer 3 Gigabit Ethernet Managed Switch CLI Manual
298
Example usage:
To set the ingress checking status, the sending and receiving GVRP information :
DGS-3627:admin# config gvrp 1:1-1:4 state enable ingress_checking enable acceptable_frame
tagged_only pvid 2
Command: config gvrp 1:1-1:4 state enable ingress_checking enable acceptable_frame
tagged_only pvid 2
Success.
NOTE: When the PVID Auto Assign function is disabled, users must manually configure the PVID
for untagged ports or the host may not connect to the Switch correctly.
enable gvrp
Purpose Used to enable GVRP on the Switch.
Syntax
enable gvrp
Description
This command, along with disable gvrp below, is used to enable and disable GVRP
globally on the Switch, without changing the GVRP configuration on the Switch.
Parameters None.
Restrictions Only Administrator and Operator-level users can issue this command.
Example usage:
To enable the generic VLAN Registration Protocol (GVRP):
DGS-3627:admin# enable gvrp
Command: enable gvrp
Success.
DGS-3627:admin#
disable gvrp
Purpose Used to disable GVRP on the Switch.
Syntax
disable gvrp
Description
This command, along with enable gvrp above, is used to enable and disable GVRP on the
Switch, without changing the GVRP configuration on the Switch.
Parameters None.
Restrictions Only Administrator and Operator-level users can issue this command.
Example usage:
