A SERVICE OF

logo

Open as PDF
next previous
xStack
®
DGS-3600 Series Layer 3 Gigabit Ethernet Managed Switch CLI Manual
179
21
COUNTER COMMANDS
The Counter commands in the Command Line Interface (CLI) are listed (along with the appropriate parameters) in the
following table.
Command Parameters
show packet ports <portlist>
show error ports <portlist>
show utilization ports
clear counters {ports <portlist>}
Each command is listed, in detail, in the following sections.
show packet ports
Purpose Used to show statistics about the packets which were sent and received by the switch.
Syntax
show packet ports <portlist>
Description The show packet ports command shows statistics about the packets which were sent and
received by the switch.
Parameters
portlist - Specifies a range of ports to be displayed. (Unit ID: port number).
Restrictions None.
Example usage:
To display the packets analysis for port 7 of unit 2: