xStack
®
DGS-3600 Series Layer 3 Gigabit Ethernet Managed Switch CLI Manual
509
config ospf aggregation
Parameters
<area_id> − A 32-bit number in the form of an IP address (xxx.xxx.xxx.xxx) that uniquely identifies
the OSPF area in the OSPF domain.
<network_address> − The 32-bit number in the form of an IP address that uniquely identifies the
network that corresponds to the OSPF Area.
lsdb_type − The type of address aggregation. The user has two choices for the LSDB type:
• summary – Choosing this LSDB type will summarize routes that are entering the OSPF
area by redistribution.
• advertise [enable | disable] − Allows for the advertisement trigger to be enabled or
disabled.
• nssa_ext – Choosing this LSDB type will summarize routes that are entering the OSPF
NSSA from an external source.
• advertise [enable | disable]
−
Allows for the advertisement trigger to be enabled or
disabled.
Restrictions Only Administrator and Operator-level users can issue this command.
Usage example
To configure the OSPF area aggregation settings:
DGS-3627:admin# config ospf aggregation 10.1.1.1 10.48.76.122/16 lsdb_type summary
advertise enable
Command: config ospf aggregation 10.1.1.1 10.48.76.122/16 lsdb_type summary advertise
enable
Success.
show ospf aggregation
Purpose Used to display the current OSPF area aggregation settings.
Syntax
show ospf aggregation {<area_id>}
Description This command will display the current OSPF area aggregation settings.
Parameters
<area_id> − Enter this parameter to view this table by a specific OSPF area ID.
Restrictions None.
Example usage:
To display OSPF area aggregation settings:
