xStack
®
DGS-3600 Series Layer 3 Gigabit Ethernet Managed Switch CLI Manual
380
50
JAPANESE WEB-BASED ACCESS CONTROL (JWAC)
COMMANDS
The Japanese Web-based Access Control (JWAC) commands in the Command Line Interface (CLI) are listed (along with
the appropriate parameters) in the following table.
Command Parameters
enable jwac
disable jwac
enable jwac redirect
disable jwac redirect
enable jwac forcible_logout
disable jwac forcible_logout
enable jwac udp_filtering
disable jwac udp_filtering
enable jwac
quarantine_server_monitor
disable jwac
quarantine_server_monitor
config jwac
quarantine_server_error_timeout
<sec 5-300>
config jwac redirect {destination [quarantine_server | jwac_login_page] | delay_time <sec 0-10>} (1)
config jwac virtual_ip <ipaddr> {url [<string 128> | clear]}
config jwac quarantine_server_url <string 128>
config jwac
clear_quarantine_server_url
config jwac update_server [add | delete] ipaddress <network_address> {[tcp_port < port_number 1-65535>
| udp_port < port_number 1-65535>]}
config jwac switch_http_port <tcp_port_number 1-65535> {[http | https]}
config jwac ports
[<portlist> | all] {state [enable | disable] | max_authenticating_host <value 0
-50> | aging_time [infinite | <min 1-1440>] | idle_time [infinite | <min 1-1440>] |
block_time [<sec 0-300>] | auth_mode [host _based | port_based]} (1)
config jwac radius_protocol [local | pap | chap | ms_chap | ms_chapv2 | eap_md5]
create jwac user <username 15> {vlan <vlanid 1-4094>}
config jwac user <username 15> {vlan <vlanid 1-4094>}
delete jwac [user <username 15> | all_users]
show jwac user
clear jwac auth_state [ports [all | <portlist>] { authenticated | authenticating | blocked } | mac_addr
<macaddr>]
config jwac authorization attributes {radius [enable| disable] | local [enable | disable]} (1)
