xStack
®
DGS-3600 Series Layer 3 Gigabit Ethernet Managed Switch CLI Manual
571
config bandwidth_control
minimum granularity) * minimal granularity
Restrictions Only Administrator and Operator-level users can issue this command.
Example usage:
To configure the transmit bandwidth rate on port 1:1-1:10 to be 100 Kbits/sec:
DGS-3627:admin# config bandwidth_control 1:1-1:10 tx_rate 100
Command: config bandwidth_control 1:1-1:10 tx_rate 100
The setting value is not an integer multiple of granularity 64. The closest value
64 is chosen.
Success.
show bandwidth_control
Purpose Used to display the port bandwidth control table.
Syntax
show bandwidth_control {<portlist>}
Description The show bandwidth_control command displays the port bandwidth configuration.
The bandwidth can also be assigned by the RADIUS server through the authentication
process. If the RADIUS server has assigned the bandwidth, then the RADIUS-assigned
bandwidth will be the effective bandwidth. The authentication with the RADIUS server can be
either per port or per user. For per-user authentication, there may be multiple bandwidth
control values assigned when there are multiple users attached to the specific port. In this
case, the largest assigned bandwidth value will be applied to the effective bandwidth for this
specific port. Note that only devices that support MAC-based VLANs can provide per user
authentication.
Parameters
portlist - Specifies a range of ports to be displayed.
If no parameter is specified, the system will display all ports bandwidth configurations.
Restrictions None.
Example usage:
To display port bandwidth control table for ports 1:1-1:10:
