xStack
®
DGS-3600 Series Layer 3 Gigabit Ethernet Managed Switch CLI Manual
413
Command Parameters
enable lldp
disable lldp
config lldp message_tx_interval <sec 5-32768>
config lldp message_tx_hold_multiplier <int 2–10>
config lldp tx_delay <sec 1-8192>
config lldp reinit_delay <sec 1-10>
config lldp notification_interval <sec 5-3600>
config lldp ports
[<portlist>|all] notification [enable | disable]
config lldp port
s [<portlist>|all] admin_status [tx_only | rx_only | tx_and_rx | disable]
config lldp ports
[<portlist>|all] mgt_addr [ipv4 <ipaddr> | ipv6 <ipv6addr>] [enable | disable]
config lldp ports
[<portlist>|all] basic_tlvs [all | {port_description | system_nam
e | system_description | system_capabilities}] [enable | disable]
config lldp ports
[<portlist>|all] dot1_tlv_pvid [enable | disable]
config lldp ports
[<portlist>|all] dot1_tlv_protocol_vid [vlan [all | <vlan_name 32> ] | vlanid <vidlist> ]
[enable | disable]
config lldp ports
[<portlist>|all] dot1_tlv_vlan_name [vlan [all | <vlan_name 32> ] | vlanid <vidlist> ]
[enable | disable]
config lldp ports [<portlist>|all] dot1_tlv_ protocol_identity[all | { eapol | lacp | gvrp | stp}] [enable |
disable]
config lldp ports
[<portlist>|all] dot3_tlvs [all | {mac_phy_configuration_status | link aggregation |
maximum_frame_size}] [enable | disable]
config lldp forward_message [enable | disable]
show lldp
show lldp mgt_addr {[ipv4 <ipaddr> | ipv6 <ipv6addr>]}
show lldp ports
{<portlist>}
show lldp local_ports
{<portlist>} {mode [brief | normal | detailed]}
show lldp remote_ports
{<portlist>} {mode [brief | normal | detailed]}
show lldp statistics
show lldp statistics ports
{<portlist>}
Each command is listed, in detail, in the following sections.
