A SERVICE OF

logo

Open as PDF
next previous
xStack
®
DGS-3600 Series Layer 3 Gigabit Ethernet Managed Switch CLI Manual
53
Please note that user granted access to the Switch will be granted normal user privileges on the Switch. To gain access
to admin level privileges, the user must enter the enable admin command and then enter a password, which was
previously configured by the administrator of the Switch.
The Access Authentication Control commands in the Command Line Interface (CLI) are listed (along with the appropriate
parameters) in the following table.
NOTE: TACACS, XTACACS and TACACS+ are separate entities and are not compatible. The Switch
and the server must be configured exactly the same, using the same protocol. (For example, if the
Switch is set up for TACACS authentication, so must be the host server.)