xStack
®
DGS-3600 Series Layer 3 Gigabit Ethernet Managed Switch CLI Manual
393
show jwac
Purpose Used to display the configuration of JWAC.
Syntax
show jwac
Description The show jwac command allows you to show all the configuration of JWAC.
Parameters None.
Restrictions None.
Example usage:
To display global configuration of JWAC:
DGS-3627:admin# show jwac
Command: show jwac
State : Enabled
Enabled Ports : 1:1,1:11,1:23,1:25,1:35
Virtual IP/URL : 1.1.1.1/www.kyoto.ac.jp
Switch HTTP Port : 21212 (HTTP)
UDP Filtering : Enabled
Forcible Logout : Enabled
Redirect State : Enabled
Redirect Delay Time : 3 Seconds
Redirect Destination : Quarantine Server
Quarantine Server : http://172.18.212.147/pcinventory
Q-Server Monitor : Enabled (Running)
Q-Server Error Timeout : 5 Seconds
RADIUS Auth-Protocol : PAP
RADIUS Authorization : Enabled
Local Authorization : Enabled
show jwac update_server
Purpose Used to display the configuration of JWAC update server.
Syntax
show jwac update_server
Description This command displays the configured update server’s network and their accessible ports.
The function will use system’s common resource, thus some entries may not active if the
resource is not sufficient when JWAC is enabled.
Parameters None.
Restrictions None.
Example usage:
To show update server: