xStack
®
DGS-3600 Series Layer 3 Gigabit Ethernet Managed Switch CLI Manual
365
47
IPV6 NEIGHBOR DISCOVER COMMANDS
The IPv6 Neighbor Discover commands in the Command Line Interface (CLI) are listed (along with the appropriate
parameters) in the following table.
Command Parameters
create ipv6 neighbor_cache ipif <ipif_name 12> <ipv6addr> <macaddr>
delete ipv6 neighbor_cache ipif [<ipif_name 12> | all] [<ipv6addr> | static | dynamic | all]
show ipv6 neighbor_cache ipif [<ipif_name 12> | all] [ipv6address <ipv6addr> | static | dynamic | all]
config ipv6 nd ns ipif <ipif_name 12> retrans_time <millisecond 0-4294967295>
config ipv6 nd ra ipif <ipif_name 12> {state [enable | disable] | life_time <sec 0-9000> |
reachable_time < millisecond 0-3600000> | retrans_time <millisecond 0-
4294967295> | hop_limit <value 0-255> | managed_flag [enable | disable] |
other_config_flag [enable | disable] | min_rtr_adv_interval <sec 3-1350> |
max_rtr_adv_interval <sec 4-1800>} (1)
config ipv6 nd ra prefix_option ipif <ipif_name 12> <ipv6networkaddr> {preferred_life_time <sec 0-4294967295> |
valid_life_time <sec 0-4294967295> | on_link_flag [enable | disable] |
autonomous_flag [enable | disable]} (1)
show ipv6 nd {ipif <ipif_name 12>}
Each command is listed, in detail, in the following sections.
create ipv6 neighbor_cache
Purpose Adds a static neighbor on an IPv6 interface.
Syntax
create ipv6 neighbor_cache ipif <ipif_name 12> <ipv6addr> <macaddr>
Description Adds a static neighbor on an IPv6 interface.
Parameters
ipif_name - Interface’s name.
ipv6addr - The address of the neighbor.
macaddr - The MAC address of the neighbor.
Restrictions Only Administrator and Operator-level users can issue this command.
Example usage:
To create a static neighbor cache entry on the interface System, with an IPv6 address of 3ffc::1 and a MAC address of
00:01:02L03:04:05:
DGS-3627:admin# create ipv6 neighbor_cache ipif System 3ffc::1 00:01:02:03:04:05
Command: create ipv6 neighbor System _cache ipif 3FFC::1 00:01:02:03:04:05
Success.
